Sandstone grinding in electromagnetic mill – case study

Anna Lis

Abstract

The article presents a comparison of the use of a ball mill and an electromagnetic mill for the grinding sandstones, taking into account the obtained grain fractions. The simplified principle of an electromagnetic mill operation has been described, as a relatively new device, which is increasingly gaining popularity. The same amount of feed was mixed with similar values of individual fractions in both devices. On the basis of the obtained results, the performance of both mills was compared and the effectiveness of using an electromagnetic mill was determined for further use.
Author Anna Lis (FoPaPE / IoAEaI)
Anna Lis,,
- Institute of Agricultural Engineering and Informatics
Journal seriesIOP Conference Series: Earth and Environmental Science, [Earth and environmental science], ISSN 1755-1307, e-ISSN 1755-1315, (0 pkt)
Issue year2019
Vol362
Pages1-4
Publication size in sheets0.5
Article number012138
ConferenceWorld Multidisciplinary Earth Sciences Symposium (WMESS 2019), 09-09-2019 - 13-09-2019, Praga, Czechy
DOIDOI:10.1088/1755-1315/362/1/012138
URL https://iopscience.iop.org/article/10.1088/1755-1315/362/1/012138/pdf
Languageen angielski
LicenseJournal (articles only); author's original; Uznanie Autorstwa (CC-BY); after publication
File
Sandstone grinding in electromagnetic mill – case study of 02-12-2019
255,14 KB
Score (nominal)5
Score sourcejournalList
Citation count*
Additional fields
FinansowanieThe publication was financed by the National Center for Research and Development under the strategic program “Regional science and research agendas” Intelligent Development Operational Program 4.1.2 (POIR.04.01.02-00-0022/18-00).
Cite
Share Share

Get link to the record


* presented citation count is obtained through Internet information analysis and it is close to the number calculated by the Publish or Perish system.
Back
Confirmation
Are you sure?